Adding Nas Server; Figure 7-10 Recording 1; Figure 7-11 Add Nas Server - Honeywell 30 Series Configuration Manual

Figure 7-10 Recording 1

•
Click Recording 1 (Name): Opens the Recording Settings page to modify.
•
Click ON (Status): The Status will become OFF and stop recording.
•
Click SD (Destination): Opens the file list of recordings.

Adding NAS Server

Figure 7-11 Add NAS Server

Click Add NAS server to open the server setting window and follow the steps below to set up:
1. Enter the information for your server.
Server Name: Enter a name for your server.
Network Storage Location: Enter the network storage path:
address\folder name
Workgroup: Enter the workgroup for your server.
User Name: Enter the user name for your server.
Password: Enter the password for your server.
2. Click Test to check the setting. The result will be shown in the pop-up window. If it is
successful, you will receive a test.txt file on the network storage server.
3. Click Save to complete the settings and click Close to exit the page.
Configuring Storage Settings
\\server name or IP
79