Certificates And Approvals; Ce Mark; C-Tick Symbol; Ex Approval - Endress+Hauser Proline Promag P 200 Technical Information

CE mark

C-Tick symbol

Ex approval

34

Certificates and approvals

The measuring system is in conformity with the statutory requirements of the applicable EC Directives. These
are listed in the corresponding EC Declaration of Conformity along with the standards applied.
Endress+Hauser confirms successful testing of the device by affixing to it the CE mark.
The measuring system meets the EMC requirements of the "Australian Communications and Media Authority
(ACMA)".
The measuring device is certified for use in hazardous areas and the relevant safety instructions are provided
in the separate "Safety Instructions" (XA) document. Reference is made to this document on the nameplate.
The separate Ex documentation (XA) containing all the relevant explosion protection data is available
from your Endress+Hauser sales center.
ATEX, IECEx
Currently, the following versions for use in hazardous areas are available:
Ex d
Category (ATEX)
II2G
II2D
Ex ia
Category (ATEX)
II2G
III2D
Ex nA
Category (ATEX)
II3G
Ex ic
Category (ATEX)
II3G
cCSAus
Currently, the following versions for use in hazardous areas are available:
XP (Ex d)
Class I/II/III Division 1 Groups ABCDEFG
IS (Ex i)
Class I/II/III Division 1 Groups ABCDEFG
NI (Ex nA, Ex nL)
Class I Division 2 Groups ABCD; NIFW*
*= NIFW parameter as per Control Drawings
Proline Promag P 200
Type of protection
Ex d[ia] IIC T6-T1 Gb
Ex tb IIIC T** Db
Type of protection
Ex ia IIC T6-T1 Gb
Ex tb IIIC T** Db
Type of protection
Ex nA IIC T6-T1 Gc
Type of protection
Ex ic IIC T6-T1 Gc
Endress+Hauser