ABB RELION REX640 Engineering Manual page 119

1MRS759117 A
REX640
Engineering Manual
The new symbol becomes available in Symbol Editor with the states selected for
drawing. Different drawing tools such as line, rectangle and ellipse can be used
to draw the graphics for the different states.
3. Select the symbol state to be used as the default and set is default to True in the
Object Properties pane.
GUID-BD268B88-F926-46F3-9403-95389CA6CDCE V1 EN
Figure 90: Setting the default state
4. Select the signals that should be connectable in SLD Editor via the symbol's
Signals property.
4.1. On the menu bar, point to Graphical Display Editor, point to Symbol
Editor, point to Symbol and select Object Properties.
4.2. Select Signals property and click ....
4.3. In the Signals Selection dialog, use
signals and click OK.
The connectable signal types for symbols are shown on the left side of the
Signal Selection dialog. Any signal type can be moved from the left side
to the right side and vice versa. These signal types are used to connect to
the symbol if the instance is available in the configuration.
Section 6
LHMI engineering
and to add or remove
111