Table of Contents
Advertisement
5 - Sprayer setup
Filling of rinse tank
The rinse tank is filled via the 2 inch "Rinse" coupler located below the
platform in the fluid working zone on the sprayer's left side.
To fill the rinse tank:
1. Remove the cap from the "RINSE" quick fill coupler and attach the
external supply hose.
2. Start water supply or remote fill pump that is connected to a clean
water supply.
3. Open the "RINSE" tank filling valve.
4. When rinse tank is full, turn off the "RINSE" tank filling valve.
5. Turn off water supply or remote fill pump.
6. Remove external supply hose and secure the cap to the quick fill
coupler.
ATTENTION! Only fill the rinse tank with clean water. To avoid algae developing, always drain the rinse tank if the
sprayer is not used for an extended period of time.
Filling of clean water tank
A clean water tank is fitted below the platform in the clean zone on the
sprayer's left side. The tank is easily removed for filling, or can be filled
with a hose without removal.
To remove the clean water tank, grab the handle at the top of the tank
and press up on the metal locking tab. Then tilt the tank forward and lift
the tank clear of the bottom supports.
Remove the clean water tank lid (A) and fill with clean water only.
Replace the tank by placing the bottom of the tank in the bottom
supports, then push the top of the tank back until the metal lock tab
closes around the tank handle. It may be necessary to pull the metal
locking tab down or forward to secure the tank.
To release water from the clean water tank, use valve (B). The water from
this tank is for hand washing, cleaning of clogged nozzles, etc. Only fill the clean water tank with clean water.
±
WARNING! Although the clean water tank is only filled with clean water, this water must never be used for drinking.
60
Advertisement
Table of Contents
