A-5. Emc Tables; Table 16. Guidance And Manufacturer's Declaration - Electromagnetic Emissions - Dentsply Sirona Schick 33 User Manual

A-5. EMC Tables

Table 16. Guidance and Manufacturer's Declaration - Electromagnetic Emissions

PLEASE NOTE: The USB Interface is intended for use in the electromagnetic environment specified below.
The customer or user of the USB Interface must ensure that it is used in such an environment.
E T
MISSIONS EST
RF emissions Group 1
CISPR 11
RF emissions Class B
CISPR 11
Harmonic Class D
emissions
IEC 61000-3-2
Complies
Voltage
fluctuations/ flicker
emissions
IEC 61000-3-3
Schick USB Module and Sensors
The following tables provide system compliance information to
electromagnetic compatibility (EMC) and electromagnetic immunity
(EMI) standards. To ensure conformance, the customer or user must
use the USB Interface in environments that are consistent with these
standards.
The USB cable required with the USB Interface must also comply with
the same standards. The operation of the USB Interface has been
independently tested using USB cables identified in Table 13 on page
69. Compliance to EMC and EMI standards cannot be guaranteed by
the use of alternate cables.
C
OMPLIANCE
The USB Interface uses RF energy only for its internal
function. Therefore, its RF emissions are very low and are
not likely to cause any interference in nearby electronic
equipment.
The USB Interface is suitable for use in all establishments
including domestic establishments and those directly
connected to the public low-voltage supply network that
supplies buildings used for domestic purposes.
100003870 Rev. 4
G
UIDANCE
73