2.5.
Connecting the Schick 33/Elite USB Interface
IMPORTANT! Do not connect the USB Interface and cable to your computer until after you have
successfully run the setup program. Procedures for installing these files are supplied on the previous pages.
IMPORTANT! For normal operation and to ensure compliance with regulatory EMC and EMI
standards, use only the USB cables described and specified for your system.
1
2
Figure 1. Schick 33/Elite USB Interface Cable Connections
Table 1. Schick 33/Elite USB Interface Cable Connections
N
UMBER
1
Sensor (Schick 33 shown)
2
Sensor cable connection
3
USB Interface
4
USB cable connection ("B" end of USB cable connects here)
5
USB cable connection ("A" end of USB cable connects to PC)
Schick USB Module and Sensors
The USB cable has a Series "A" USB plug on one
side and a Series "B" USB plug on the other. The
"A-type" plug connects to any available USB port
on the computer. The "B-type" plug connects to
the USB Interface.
Cable part numbers and lengths can be found in
Table 13 on page 69, as well as other orderable parts.
An illustration of the Sensor and USB Interface are shown in Figure 1
(below). For a description of cable connections to the device, refer to
Table 1 (below).
3
100003870 Rev. 4
4
D
ESCRIPTION
5
9