11.1.2. Wall-Mounting Option (with Adhesive)
11.2. Schick Sensor Holster
Figure 20. Schick Sensor Holster (Schick 33 Sensor Shown)
66
Perform the following steps to install the holder by attaching it with
Velcro adhesive to a wall or other flat surface:
1. Remove the Schick 33/Elite Interface from the holder.
2. Cut and trim a piece of Velcro adhesive (not supplied) to the
size of the back of the holder. Remove one half of the tape and
attach it to the holder.
3. Locate an accessible, stable, and flat surface for the interface.
Apply the other half of the Velcro adhesive in that location and
attach the holder securely.
4. Snap the Schick 33/Elite USB Interface into the holder with
the LEDs facing outward.
The Schick Sensor Holster is designed for easy access to, and storage
of, Schick Sensors, including Schick 33 and Schick Elite Sensors.
Several mounting options are available: (1) Wall-mounted with
fastening hardware, or (2) Attached to a wall or other acceptable
bonding surface with adhesive pad (supplied). When installing your
Sensor Holster choose a flat, stable surface that offers easy access. For
convenience, we also recommend placing the Sensor with its logo side
facing outward (as shown below).
100003870 Rev. 4
Schick USB Module and Sensors