Operation; Operating The System - Dentsply Sirona Schick 33 User Manual

4. Operation

4.1.

Operating the System

4.1.1. Power On
4.1.2. Power Off
12
1. Turn on the PC workstation used with imaging applications.
2. Connect the "B" end of the cable to the USB Interface (if not
connected already).
3. Connect the "A" end of the cable to the PC work-station (if not
connected already).
4. Connect the Sensor edge-card to the USB Interface.
5. The amber LED on the USB side of USB Interface illuminates and
turns off after a few seconds.
6. The green LED on the Sensor side of the USB Interface
illuminates and remains steady on, indicating proper current
condition for the Sensor.
1. Disconnect the USB cable from the PC workstation.
2. Disconnect the USB cable from the USB Interface.
3. Power is removed from the Schick USB Interface and Sensor
and the green LED on the Sensor side is turned off.
100003870 Rev. 4 Schick USB Module and Sensors