Button; Reset Button - Delta M Series Operation And Installation Manual

APP COMM
Connected
BLE is COMM
running
INFO Led
Firmware INFO
upgrading
Receiving INFO
image
Equipment INFO
alarm
FAULT Led
Arc fault FAULT
Ground fault FAULT
Other
Initialization OPER
BAT
COMM
INFO
5.2

Button

5.2.1

Reset button

There is button located inside the junction box, for this button, there are following functions.
1. Arc reset
Application: Clear arc fault.
Trigger condition: Press the button for 3-5 seconds.
2. Arc self-test
Application: If there is no arc fault, run arc self-test
Trigger condition: Press the button for 3-5 seconds.
2. Gateway reset
Application: gateway reset to factory status
Trigger condition: Press the button for more than 10 seconds.
Green <ON> Constant on
Green <BLINK> 1s on, 1s off
Yellow <BLINK> 1s on, 1s off
Green <BLINK> 1s on, 1s off
Yellow <ON> Constant on
Red <ON> Constant on
Red <BLINK> 1s on, 1s off
Green <ON> On until done
Green <ON> On until done
Green <ON> On until done
Green <ON> On until done
APP is connected
BLE is running
Firmware upgrading is ongoing
Inverter is receiving image file
External event occurs and inverter
is unable to run
Arc fault occurs
Ground fault occurs
Inverter initialization when grid is
changing from disconnected into
connected.
Only BLINK for 2 cycles in
one minute
Reset button
43