Delta M Series Operation And Installation Manual page 16

A further description of the equipment features:
(1) Solar Inverter Power Box - This is the inverter section of the assembly. This section is sealed
at the factory and there are no user-serviceable parts inside. All wiring to install the inverter is
done in the wiring box.
(2) Wiring Box Cover - This is the cover for the wiring compartment. The removal procedure is
shown on page 30. Please note the DC disconnnect must be in the OFF position before this
cover can be removed.
(3) LED Lights - The three LED lights indicate errors or status as described in section 8.
(4) Mounting Plate - The inverter ships with a mounting plate that allows easily assembly of the
inverter to a wall.
(5) Wiring Box - This is the compartment where all the wiring for the inverter inputs and outputs
plus the RS485 communication are done.
(6) Conduit Plugs - There are 6 - 3/4" conduit openings and 2 - 1/2" conduit openings. Each
conduit opening comes fitted with a conduit plug that should be removed before installing conduit
fittings. Conduit fittings need to be water tight with either NEMA 4, 4X, 6, or 6X rated, and insula-
ted type is preferred.
DC Disconnect shown with lock in off position. There are one openings on the disconnect where a
padlock can be attached as shown above.
14