Compaq RA8000 User Manual page 139

1. Insert the new array controller into its slot, and engage its retaining levers.
One or two host bus cables [HSG80] or one or two trilink
connectors with host bus cables (or terminators) [HSZ80]
may be attached, depending on the configuration.
2. If your array controller is an HSZ80, remove the trilink connectors from the new
array controller and transfer the host bus cables (with trilinks attached) to the new
array controller. If the subsystem is equipped with an HSG80, connect the fibre
channel containing the FC cables to the new HSG80 array controller.
3. Connect a PC or terminal to the array controller's maintenance port.
4. Remove the program card's ESD cover.
5. Press and hold the reset button while inserting the program card into the new array
controller. Release and replace the ESD cover.
6. When the CLI prompt reappears, display details about the array controller you
configured. Use the following command:
SHOW THIS_CONTROLLER FULL
7. Configure the array controller as described in the appropriate HSG80 Array
Controller ACS Version 8.x Configuration and CLI Reference Guide or the HSZ80
Array Controller ACS Version 8.x Configuration and CLI Reference Guide.
If the array controller you're installing was previously used
in another subsystem, purge its old configuration. See
"CONFIGURATION RESET" in the appropriate HSG80
Array Controller ACS Version 8.x Configuration and CLI
Reference Guide or the HSZ80 Array Controller ACS
Version 8.x Configuration and CLI Reference Guide .
8. To restore a configuration saved with the SAVE_CONFIGURATION switch, press
the reset button and device port button 6.
9. Using CLCP (Code Load Code Patch), install any patches that you had installed on
the previous array controller as described in the appropriate HSG80 Array Controller
ACS Version 8.x Maintenance and Service Guide or the HSZ80 Array Controller ACS
Version 8.x Maintenance and Service Guide.
EK–SMCPR–UG. A01
Chapter 5. Replacing Components
NOTE
NOTE
5–5