Compatibility And Power Supply; Aup Auxiliary Contacts; Ekip Rtc Contact - ABB SACE Emax 2 Series Installation, Operation And Maintenance Instructions

Compatibility and power supply The module can be installed in the presence of Ekip Dip, Touch, Hi-Touch, G Touch, and G
AUP auxiliary contacts The module is always supplied with dedicated AUP auxiliary position contacts, which in the
Ekip RTC contact The module is always supplied with an Ekip RTC auxiliary contact, that supplies the release
214 | © 2013 ABB | 1SDH001000R0002 - L7804
Continued from the previous page
With the Programmable Logic function, it is possible to program the activation of the Ekip Link
up to 4 bits, each bit according to any combination of the status bits of a release whose IP
Address has been inserted.
These four bits are indicated as states A, B, C and D remotely programmable, and their value
is transmitted to the release to which the Ekip Link module is connected.
Only with Ekip Dip releases, the module can also be used with a function similar to that one
of the Ekip Com Modbus TCP module, but with possibility to communicate only with an ABB
master (for example, Ekip Connect or Ekip Control Panel).
IMPORTANT: only one Ekip Link can be installed on the same circuit-breaker.
Hi-Touch releases, and requires the presence of an Ekip Supply module in the first slot of the
circuit-breaker terminal box.
case of a withdrawable circuit-breaker supply the signal for inserted/extracted moving part
from the fixed part.
The assembly assures that the communication is also maintained with the withdrawn moving
part.
IMPORTANT: in the presence of multiple communication modules, only one
of these can be connected to the AUP contacts.
with the signal indicating circuit-breaker ready to receive a close command.
ABB | SACE Emax 2
Electronic accessories | 11 - Ekip Link module