Self-Diagnosis; Alarms And Signals - ABB SACE Emax 2 Series Installation, Operation And Maintenance Instructions

18 - Self-diagnosis

Alarms and signals

Self-diagnosis Ekip Touch continuously monitors its own operating state and that of all the devices to which
144 | © 2013 ABB | 1SDH001000R0002 - L7804
Alarm Tests
Ekip Touch provides a series of signals that indicate its operating state, alarms present, or
configuration errors in progress.
The signals are provided:
• With LEDs, as described on page 56.
• With messages on the diagnostics bar
The messages on the diagnostics bar can be divided into 3 categories: self-diagnosis,
protection or measurement alarms, and programming error.
it is connected.
In the event of an error, the fault detected is reported:
Signal
Local bus
Trip Coil disconnected
L1 sensor Disconnected
L2 sensor Disconnected
L3 sensor Disconnected
Ne sensor Disconnected
Gext sensor Disconnected
Rating Plug Error
Internal Error
Invalid Date
CB Status Error
Rating Plug Installation Warning
Battery Low
Voltage module Installation warning
Voltage Module Error
NOTE: for resolution of the signals see section Fault resolution on page 246.
Description
No module detected on the terminal box
Trip Coil not connected
Current sensor not connected
Current sensor not connected
Current sensor not connected
Current sensor not connected
Current sensor not connected
Rating plug not connected or not installed
Internal error
Date not set
Circuit-breaker status contacts error
Rating plug not installed
Battery not working or absent
Ekip Measuring module not installed
Ekip Measuring module in error
Ekip Touch protection release | 18 - Self-diagnosis
ABB | SACE Emax 2