Roland TrueVIS VG2-640 Setup Manual page 61

Press [ ] or [ ] to select the address number.
C
Press [ ].
D
C
Repeat steps
E
Note: For the subnet mask, make the setting the same value as the one used by the computer.
Here, "255.255.255.000" is entered by way of example.
SUBNET MASK
255.255.255.000
When you have finished making the setting, press [ENTER].
F
Press [ ] to go back to the screen shown below.
G
NETWORK
SUBNET MASK
If you are using the computer and the machine on a one-to-one basis, this completes the settings to
make on the printer.
Press [MENU] to go back to the original screen. Then, proceed to
.
the Software RIP"
If you need to set the gateway address, proceed to the following procedure.
3.
Set the gateway address
Press [ ] to display the screen shown below.
A
NETWORK
GATEWAY ADDR.
Press [ ] twice to display the screen shown below.
B
GATEWAY ADDR.
000.000.000.000
Press [ ] or [ ] to select the address number.
C
Press [ ].
D
D
and to set [SUBNET MASK] to "255.255.255.000."
3. Network Settings
P. 60 "Step 3: Make the Port Settings for
2.Installation
59