Step.2:.Installing.the.cutting.tool; Step 2: Installing The Cutting Tool - Roland TrueVIS VG2-640 Setup Manual

Step 2: Installing the Cutting Tool

1.
Enter the "REPLACE BLADE" menu.
Press [MENU].
A
Press [ ] several times to display the screen shown below.
B
MENU
SUB MENU
Press [ ] once, and then press [ ] several times to display the screen shown below.
C
SUB MENU
MAINTENANCE
Press [ ] once, and then press [ ] several times to display the screen shown below.
D
MAINTENANCE
REPLACE KNIFE
Press [ENTER].
E
The cutting carriage moves to a position where blade replacement is possible.
When the following screen is displayed, open the front cover.
F
OPEN FRONT
Preparations are complete when this screen appears.
FINISHED?
2.
Install the cutting tool.
Loosen the cutting carriage screw.
A
COVER
2. Installing the Cutting Tool
2.Installation
53