Roland TrueVIS VG2-640 Setup Manual page 37

Lightly tighten the bolts connecting the rear of the stand to the arm's contact surface.
C
While pressing the side of the arm onto the stand leg, tighten the bolts.
Fully tighten the bolts in the order of
D
Attach the other arm to the right side as seen from the rear of the machine.
E
Attach the media holder adjuster to the right arm as seen from the rear of the ma-
F
chine.
Pass the protrusions of the media holder adjuster
then temporarily tighten the bolts so that the media holder adjuster does not fall off.
1 2
(stand rear), (stand side).
2
through the notches on the arm
1. Assembly and Ink Filling
Tighten
temporarily
Bolts (short): 2
Tighten fully
Bolts (short): 4
1
, and
Tighten
temporarily
Bolts (short): 2
2.Installation
35