Roland TrueVIS VG2-640 Setup Manual page 30

1. Assembly and Ink Filling
Fully tighten the bolts in the 4 upper locations and then in the 4 locations on the
C
sides.
Use the pipe when tightening the bolts in the upper locations. When tightening the bolts fully,
tighten them securely. Loose bolts may cause the stand to wobble.
Assemble the opposing stand leg by following the same procedure from step
D
C
step .
Position the stand legs parallel to each other and separated by approximately 1,800
E
mm (70.9 in.) for the 64-inch model or approximately 1,500 mm (59.1 in.) for the 54-
inch model.
Position the legs so that the L-shaped brackets face the inside and the bent side of the tabletop
plate faces down for each leg.
Place the stand stay on the stand legs.
F
Place the stand stay so that its inside touches the L-shaped brackets and the stand legs in order
to make the 2 stand legs parallel.
28
2.Installation
Pipe
About 1,800 mm (70.9 in.)
(64-inch model)
About 1,500 mm (59.1 in.)
(54-inch model)
Set this part on the bottom.
Tighten fully
Bolts (short): 8
A
Position the surface with attach-
ment holes toward the casters.
to