Roland TrueVIS VG2-640 Setup Manual page 34

1. Assembly and Ink Filling
2.
Fix the printer unit to the stand.
With six or more workers, firmly hold the lifting bars and lift up the printer unit.
A
CAUTION
CAUTION
Caution
Place the printer unit on the stand, and then temporarily tighten the bolts in the order
B
of 1 , 2 .
Set the assembled stand upright, and then fix the printer unit to it by tightening the (long) bolts (8
locations in total). Use a washer for each (long) bolt.
32
2.Installation
Be sure to perform this work with six or more people. Have at least one
person hold each of the four ends of the lifting bars and at least one person
hold each end of the housing.
Tasks that require undue effort when performed by a small number of per-
sons may result in physical injury. Dropping this machine may result in injury.
Before lifting up the printer unit, check that the lifting bars do not rattle.
If the lifting bars rattle, retighten the lifting bar fixing bolts fixing them in
place.
When not using the lifting bars, be sure to perform the work with eight or
more people.
Tasks that require undue effort when performed by a small number of
persons may result in physical injury. Dropping this machine may result in
injury.
Tighten
temporarily
Bolts (long): 8
Washers: 8