Roland TrueVIS VG2-640 Setup Manual page 38

1. Assembly and Ink Filling
Attach the adjustment bolt
G
Tighten the adjustment bolt until the bottom of the right arm and the bottom of the
H
media holder adjuster are aligned
M E MO
At the end of the installation work, a suitably qualified worker will adjust the media adjuster holder.
Leave this work to the suitably qualified worker.
2.
Attach the media holders.
Place the shafts on the arms.
A
First insert the shafts into the holes on the right side as seen from the rear of the machine, and
then place the shafts into the holes on the left side.
36
2.Installation
1
.
Adjustment bolt
Media holder
adjuster
Arm
Align the bottom of
the media holder
adjuster with the
bottom of the arm.
2
.
Tighten fully
Adjustment bolt: 1