Taylor 428 Operator's Manual page 20

Step 3
Insert the drive shaft into the rear shell bearing and
engage the square end firmly into the female socket of
the drive unit. Be certain that the drive shaft fits into the
drive coupling without binding.
Figure 10
USE EXTREME CAUTION when handling
the beater assembly. The scraper blades are very
sharp and may cause injury.
Step 4
Before installing the beater assembly, inspect the
scraper blades and clips.
Check the scraper blades for any signs of wear or
damage. If a scraper blade is nicked or worn, replace
both blades.
Check the scraper blade clips to make sure they are
not bent and the slot is even for the entire length of the
clip. Replace any damaged clips.
Figure 11
150702
Operating Procedures
Step 5
If the blades and clips are in good condition, install the
scraper blade clip over the scraper blade. Place the
rear scraper blade over the rear holding pin (knife edge
to the outside). Holding the blade on the beater, turn
it over and install the front blade the same way.
Note: The hole on the scraper blade must fit securely
over the pin to prevent costly damage.
Step 6
Holding the blades in position, insert the beater
assembly into the freezing cylinder, and slide the
assembly into position over the drive shaft. Turn the
beater slightly to be certain that the beater is properly
seated. When in position, the beater will not protrude
beyond the front of the freezing cylinder.
16
Figure 12
Figure 13
Model 428