Taylor 428 Operator's Manual page 24

Step F - Self- Closing Door Assembly
From the back of the door, install the ice buster through
the door spout and into the slot located just above the
lower o- ring.
Figure 28
Step G - Self- Closing Door Assembly
Move the draw handle to the back position to lock the
ice buster in place.
Figure 29
Step H - Self- Closing Door Assembly
Turn the door right side up. Remove the draw valve
handle. Install it on the other side, through the longer
slot and into the draw valve hole.
Operating Procedures
Step I - Self- Closing Door Assembly
Insert the valve handle pin. Turn the pin and the draw
valve handle until the pin drops completely into place.
Note: While turning the draw valve handle, it may be
necessary to pull the draw valve handle back slightly
to allow the pin to fall in place.
Step J - Self- Closing Door Assembly
Place the o- ring onto the prime plug and lubricate.
20
Figure 30
Figure 31
Figure 32
Model 428