Taylor 428 Operator's Manual page 25

Step K - Self- Closing Door Assembly
Screw the prime plug into position on the front of the
door.
Figure 33
Step L - Self- Closing Door Assembly
Place the large rubber gasket into the groove on the
back side of the freezer door.
Figure 34
Model 428
Step M - Self- Closing Door Assembly
Slide the white, plastic front bearing onto the bearing
hub, making certain that the flanged end of the bearing
is resting against the freezer door. DO NOT lubricate
the door gasket or front bearing.
Step N - Self- Closing Door Assembly
Position the freezer door onto the four studs on the
front of the freezing cylinder and push the door into
place. Install the four handscrews onto the studs and
tighten them equally in a crisscross pattern to insure
that the door is snug. DO NOT over- tighten the
handscrews.
Note: If the freezer door does not fit into place easily,
position the open end of the beater assembly in the 11
o'clock position.
21
Figure 35
Figure 36
141119
Operating Procedures