Taylor 428 Operator's Manual page 22

Figure 18
Step 13
Insert the ice buster through the door spout and into
the slot located just above the lower o-ring.
Figure 19
Step 14
With the ice buster in place, rotate the draw valve to
allow installation of the draw handle. This will lock the
ice buster in place. Install the draw handle pin, and
close the draw valve by moving the handle to the left.
Figure 20
150123
Operating Procedures
Step 15
Place the large rubber gasket into the groove on the
back side of the freezer door. Slide the white, plastic
front bearing onto the bearing hub, making certain that
the flanged end of the bearing is resting against the
freezer door. DO NOT lubricate the door gasket or
front bearing.
Step 16
Position the freezer door on the 4 studs on the front of
the freezing cylinder. Install the handscrews. Tighten
equally in a criss-cross pattern to insure the door is
snug. Do not over-tighten.
Step 17
Position the torque arm by inserting it through the slot
in the torque switch arm and down into the hole in the
torque rotor which protrudes from the door. Verify
proper installation by moving the torque rotor back and
forth to be sure it moves freely and easily.
Proceed to Step 18 on page 22.
18
Figure 21
Figure 22
Model 428