FERRI TR Series Maintenance And Use Manual page 8

To work in safety you must:
1) Apply the general precautions for the use of all mechanical means as set out in Chap. 3;
2) Always follow the instructions for use given in the USE and MAINTENANCE manual or, in the case of particularly complex equi-
pment, follow specific courses offered by manufacturers, dealers, technical assistants, etc.;
3) Do not remove, tamper with or modify any part of the machine if this is not contemplated in the use and maintenance ma-
nual;
4) Repair or replace the guards and any worn or broken parts following the indications given in the use and maintenance ma-
nual;
5) Ensure that the safety decals showing the warning signals are kept in good condition;
6) Carry out maintenance on the machine according to the instructions given in the use and maintenance manual;
7) Check that the safety regulations required by law are respected and, if they are not, apply to specialised technical personnel
(manufacturers, dealers, technical assistants, etc.).
8) Keep all the guards in perfect working order.
IMPORTANT WARNING:
All the technical precautions, as regards safety against thrown objects, adopted in the design
of machines (at the present state of the art they are the same for all manufacturers) do not
allow absolute safety to be achieved.
WARNING There unfortunately remains a residual risk that cannot be eliminated and which, besides
depending on the probabilistic nature of the trajectory of the cut material, is inherent to the
particular nature of operation of the machines.
So it may happen that, even during appropriate use of the machine, small stones, chips or
other material may escape the protective barriers and be thrown far away.
It is therefore absolutely obligatory that there be NO ONE IN THE RANGE OF ACTION OF
THE MACHINE (AT LEAST 50 YARDS) DURING ITS OPERATION.
In particular, it is recommended to take great care when working near roads and/or buil-
dings.
Before assembling any machine with electric/electro-hydraulic controls and/or heat exchanger on the
tractor YOU MUST read the assembly instructions on the electrical connections.
Failure to observe the said instructions faithfully may result in considerable damage to the electrical sy-
stem, thereby invalidating the warranty of the same.
8
PREFACE
CAUTION
TR-TRM
Rev. 01.00