To The New Operator Or Owner - FERRI TR Series Maintenance And Use Manual

SAFETY RULES
■
Always know the area you are shredder. Never operate shredder in an area that has hidden obstacoles.
■
Avoid operation on steep slopes.
■
Do not stop or start sudddenly when going up or down a hill.
■
Review safety instructions with all operators annually.
■
Never leave tractor while the machine is in the lifted position. Lower the machine carefully to the ground before the operator
leave the tractor.
■
Do not put hands or feet under lifted components.
Safe operating speed depends on terrain condition and material type, density and height of
cut.
WARNING
Use slow operating speeds when cutting on or near steep slopes, ditches, drop-offs, power
lines, overhead obstructions and when debris or object are to be avoided.
WARNING
Avoid operating in reverse direction, if it's possible, when work with 2 machines.
DANGER
3.3.1 To the new operator or owner
It is the responsability of the owner or operator to read this manual and to train all other operators before they start working with
the machine. In addition to the design and configuration of equipment, hazard control and accident prevention are depen-
dent upon the awareness, concern and prudence of personnel involved in the operation, trasport, maintenance and storage of
equipment or in the use and maintenance of facilites.
Follow all safety instructions exactly. Safety is everyone's business. By following recommended procedures, a safe working en-
vironment is provided for the operator, bystanders and the area around the worksite. Untrained operators are not qualified to
operate the machine.
3.4 Safety rules concerning the hydraulic system
Any intervention or maintenance on the hydraulic system has to be carried out by duly edu-
cated personnel.
WARNING
■
Replace any worn, cut, abraded, flattened or crimped hoses and metal lines.
■
Do not attempt any makeshift repairs to the hydraulic lines, fittings or hoses by using tape, clamps or cements. The hydraulic
system operate under extremely high-pressure. Such repairs will fail suddenly and create a hazardous and unsafe condition. If
injury by a concentrated high-pressure stream of hydraulic fluid, seek medical attention immediately. Serious infection or toxic
reaction can develop from hydraulic fluid piercing the skin superface.
■
Before applying pressure to the system, make sure all components are tight and that lines, hoses and couplings are not da-
maged.
■
Stop immediately in case of oil leaks.
■
IMPORTANT: do not look for oil leaks with bare hands, but always with the aid of suitable protective gloves.
■
Oil under strong pressure may seep into the skin causing serious infections or toxic reaction. In this case contact a doctor
immediately.
■
Use a piece of wood or cardboard as a backstop instead of hands to isolate and identify a leak.
■
Check the flexible pipes; if they are worn or damaged they must be replaced (at least every 6 years).
■
Before working on the hydraulic system, lower the end tool, exhaust all pressure and turn off the tractor.
■
Used oils and greases must be stored and disposed according to antipollution rules.
■
On machines equipped with, the hydraulic plant pressure haven't to exceed 190 bar.
■
When the machine non is not coupled to power takeoff, the hydraulic pipes and the PTO shaft must be placed in the supports
provided.
22
TR-TRM
Rev. 01.00