Operating Hazard Area - FERRI TR Series Maintenance And Use Manual

Rev. 01.00
3.6 Operating hazard area
■
Objectes can be thrown out from under the machine with sufficient force to severely injure people. Stay away from machine
when it is running (at least 50 yards). Keep others away.
■
Stay out of shaded hazard area.
■
Always know where all additional personnel are located when operating the machine. Never allow anyone within the hazard
area.
3.7 Danger
Pay special attention when working under or
near electric lines, an electric arc may be relea-
sed (FIG. 3.2).
DANGER
For the max cutting width please refer to TAB2
in chapter 2.
CAUTION
3.8 Safety signs
3.8.1 Replacing Safety signs
■
Keep safety signs clean and legible at all times.
■
Replace safety signs that are missing or have become illegible.
■
Replace parts that displayed a safety sign should also display the current sign.
■
Safety signs are available from your Distributors or factory..
How to install Safety Signs:
■
Be sure that the installation area is clean and dry.
■
Be sure temperature is above 10°C (50°F).
■
Determine exact position before you remove the backing paper.
■
Remove the smallest portion of the split backing paper.
■
Align the sign over the specified area and carefully press the small portion with the exposed sticky backing in place.
■
Slowly peel back the remaining paper and carefully smooth the remaining portion of the sign in place.
■
Small air pockets can be pierced with a pin and smoothed out using the piece of sign backing paper.
TR-TRM
SAFETY RULES
FIG. 3.2
25