Driver Equipment And Protections - FERRI TR Series Maintenance And Use Manual

Rev. 01.00
Be sure that hydraulic hoses are correctly connected and still remembering that their
reversing cause opposite movements to those driven.
Relieve hydraulic pressure before performing maintenance or repairs. Be sure there's no pressure inside hydraulic system.
Push and pull the remote cylinders levers in and out several times prior to starting any maintenance or repair work.
3.5 Driver equipment and protections
■
In order to protect the operator from possible flying debris, stones or other materials, it is recommended to fit two protection
grills (1) to the operator's cab (working side), so that the debris thrown by the end tool cannot reach the glass of the cab and
break it, causing injuries to the operator (FIG. 3.1).
■
It is recommended to fit 5 mm sheets of polycarbonate (2) or, as an alternative, a single steel bar 10mm thick under the
protection grills (1). They will prevent small stones and fragments from hitting the glass of the cab (FIG. 3.1).
■
Attach the machine only to tractors with approved type anti-roll over driving cab (ROPS).
■
The operator and all personnel must wear a safety helmet and eye protectors as protection against possible flying material.
RIGHT
LEFT
TR-TRM
SAFETY RULES
FIG. 3.1
2