ABB Relion 615 Series Operation Manual page 59

1MAC054853-MB B
615 series ANSI
Operation Manual
For parameters with defined steps, digits smaller than the step value
cannot be edited.
3.
Press or to move the cursor to another digit.
4. To select the minimum or maximum value, select the arrow symbol in front of the
value.
•
To set the value to the maximum, press
•
To set the value to the minimum, press
A070756 V3 EN
Figure 24: Arrow symbol is active, the value is set to the maximum
After pressing , the previous value can be restored by pressing
versa. Another press of
symbol in front of the value is ↕, when the previous value is shown.
A070757 V3 EN
Figure 25: Restoring the previous value
.
.
or sets the value to the lower or higher limit. The
Section 4
Using the HMI
once, and vice
51