Section 8
Commissioning
128
A071164 V1 EN
Figure 85:
Setting IP address and subnet mask
5.
Close all open windows by clicking OK and start PCM600.
Administrator rights are requested to change the configuration as
described above.
Setting protection relay's IP address in PCM600
In PCM600 the protection relay's IP address can be defined via the first window of the
wizard by including a new protection relay in the project or by entering the protection
relay's IP address in the Object Properties window.
1.
Select the protection relay to which you want to define the IP address.
2.
Open the Object Properties window.
3.
Place the cursor in the IP Address row and enter the IP address.
1MAC054853-MB B
615 series ANSI
Operation Manual