Table of Contents
Advertisement
Serial Startup Code LF Enable [Y/N]=N?
The list of LED/serial codes is included in the section on MPU,
Hardware, and Firmware Initialization in Chapter 1 of the PPCBug
Firmware Package User's Manual.
Configuring the VMEbus Interface
ENV asks the following series of questions to set up the VMEbus interface
for the MVME2300SC modules. To perform this configuration, you
should have a working knowledge of the Universe ASIC as described in
your MVME2300 Series VME Processor Module Programmer's
Reference Guide.
VME3PCI Master Master Enable [Y/N] = Y?
PCI Slave Image 0 Control = 00000000?
The configured value is written into the LSI0_CTL register of the
Universe chip.
PCI Slave Image 0 Base Address Register = 00000000?
The configured value is written into the LSI0_BS register of the
Universe chip.
PCI Slave Image 0 Bound Address Register = 00000000?
The configured value is written into the LSI0_BD register of the
Universe chip.
PCI Slave Image 0 Translation Offset = 00000000?
The configured value is written into the LSI0_TO register of the
Universe chip.
3-21
Set up and enable the VMEbus Interface. (Default)
Y
Do not set up or enable the VMEbus Interface.
N
Modifying the Environment
3
Advertisement
Table of Contents
