Motorola MVME2300SC Series Installation And Use Manual page 32

Hardware Preparation and Installation
1
1-14
4. Place the PMCspan on top of the MVME2300SC module. Align the
mounting holes in each corner to the standoffs, and align PMCspan
connector P4 with MVME2300SC connector J6.
5. Gently press the PMCspan and MVME2300SC together, making
sure that P4 is fully seated into J6.
6. Insert the four short Phillips screws through the holes at the corners
of the PMCspan and into the standoffs on the MVME2300SC
module. Tighten the screws.
The screws have two different head diameters. Use the
Note
screws with the smaller heads on the standoffs next to
VMEbus connectors P1 and P2.
Computer Group Literature Center Web Site