Figure 1-3. Typical Single-Width Pmc Module Placement On Mvme2300Sc - Motorola MVME2300SC Series Installation And Use Manual

Hardware Preparation and Installation
1

Figure 1-3. Typical Single-width PMC Module Placement on MVME2300SC

1-12
3. Remove the PCI filler plate from the selected PMC slot in the front
panel of the MVME2300SC. If you are installing a double-width
PMC, remove the filler plates from both PMC slots.
4. Slide the front panel(s) of the PMC module into the front panel
opening(s) from behind and place the PMC module on top of the
MVME2300SC.
The PMC front panel should fit snugly and the four connectors on
the underside of the module should connect smoothly with the
corresponding connectors (J11/12/13/14 or J21/22/23/24 for a
single-width PMC, all eight for a double-width PMC) on the
MVME2300SC.
5. Insert the four short Phillips screws through the holes at the front
and rear corners of the PMC module, into the standoffs on the
MVME2300SC. Tighten the screws.
6. If you are installing two single-width PMCs, repeat the above
procedure for the second PMC.
Computer Group Literature Center Web Site
2387 9810