Primary Pmcspan Module - Motorola MVME2300SC Series Installation And Use Manual

Primary PMCspan Module

To install a PMCspan-002 PCI expansion module on your
MVME2300SC, refer to
procedure assumes that you have read the user's manual that was furnished
with the PMCspan module, and that you have installed the selected PMCs
on the PMCspan according to the instructions given in the PMCspan and
PMC manuals.
1. Perform an operating system shutdown. Turn the AC or DC power
Inserting or removing modules with power applied may result
!
in damage to module components.
Caution
Dangerous voltages, capable of causing death, are present in
!
this equipment. Use extreme caution when handling, testing,
and adjusting.
Warning
2. If the MVME2300SC has already been installed in the chassis,
Avoid touching areas of integrated circuitry; static discharge
!
can damage these circuits.
Caution
3. Attach the four standoffs to the MVME2300SC module. For each
1-13
Figure 1-4
off and remove the AC cord or DC power lines from the system.
Remove chassis or system cover(s) as necessary for access to the
VME card cage.
carefully remove it from the VMEbus card slot and lay it flat, with
connectors P1 and P2 facing you.
standoff:
– Insert the threaded end into the standoff hole at each corner of
the VME processor module.
– Thread the locking nuts onto the standoff tips.
– Tighten the nuts with a box-end wrench or a pair of needle nose
pliers.
Installing the Hardware
and perform the following steps. This
1