Mvme2300Sc - Motorola MVME2300SC Series Installation And Use Manual

Hardware Preparation and Installation
1

MVME2300SC

!
Caution
!
Warning
1-18
6. Gently press the two PMCspan modules together, making sure that
P3 is fully seated in J3.
7. Insert the four short Phillips screws through the holes at the corners
of PMCspan-010 and into the standoffs on the primary PMCspan-
002. Tighten the screws.
The screws have two different head diameters. Use the
Note
screws with the smaller heads on the standoffs next to
VMEbus connectors P1 and P2.
Before installing the MVME2300SC into your VME chassis, ensure that
the jumpers on the MVME2300SC J7, J8, J9, and J10 headers are
configured, as previously described. This procedure assumes that you have
already installed the PMCspan module(s) if desired, and any PMCs that
you have selected.
Proceed as follows to install the MVME2300SC in the VME chassis:
1. Attach an ESD strap to your wrist. Attach the other end of the ESD
strap to an electrical ground (refer to Installation Preliminaries).
The ESD strap must be secured to your wrist and to ground
throughout the procedure.
a. Ensure that the AC or DC power is switched off and remove the
AC cord or DC power lines from the system.
Inserting or removing modules while power is applied could result in
damage to module components.
Dangerous voltages, capable of causing death, are present in this
equipment. Use extreme caution when handling, testing, and adjusting.
2. Remove chassis or system cover(s) as instructed in the user's
manual for the equipment.
3. Remove the filler panel from the card slot where you are going to
install the MVME2300SC. If you have installed one or more
Computer Group Literature Center Web Site