Date And Time - Memmert VO Series Operating Manual

7.3.7 Gateway
The setup entry gateway is used to connect two networks
with different protocols.
The gateway is set the same way as the IP address (see
page 50).

7.4 Date and time

TIME
In the display, you can set the date and time, time zone and daylight saving time.
Always set the time zone (and daylight saving time yes/no) before setting the date
and time. Avoid changing the set time after that since this can lead to gaps or over-
lapping when recording measured values. If you still need to change the time, you
should not run a program immediately before or after doing so.
1. Activate the time setting. To do so,
press the activation key on the right
TIME
side of the
enlarged and the first adjustment op-
Date
tion ( ) automatically highlighted.
2. Turn the turn control until
is highlighted.
3. Accept the selection by pressing the
confirmation key.
4. Set the time zone of the installation
site with the turn control, e.g. 00:00
for the UK, and 01:00 for France, Spain
or Germany. Accept the selection by
pressing the confirmation key.
5. With the turn control, select the
light savings
entry.
D39374 | Date 08/2018
display. The display is
Time zone
Day-
2/2
Remote Control Off
Gateway
Date and time
Date 12 . 05 . 2012
Time 12 : 00
Time zone GMT 01:00
Daylight savings
Date
Time
Time zone
Daylight savings
Date
Time
Time zone
Daylight savings
Date
Time
Time zone
Daylight savings
Menu mode
192.168.5 .1
Date 12 . 05 . 2012
Time 12 : 00
Time zone GMT 01:00
Daylight savings
12 . 05 . 2012
12 : 00
GMT 01:00
12 . 05 . 2012
12 : 00
GMT 00:00
12 . 05 . 2012
12 : 00
GMT 00:00
53