Pressure Monitoring - Memmert VO Series Operating Manual

10. Press the confirmation key to confirm.
Temperature monitoring is now active.
In menu mode you can set, whether an
acoustic signal should be triggered in
the event of an alarm (see page 60))

5.5 Pressure monitoring

If the pressure monitoring was triggered, this is indicated
by the pressure display: by the actual pressure highlighted
in red and an alarm symbol
acoustic alarm has been activated in menu mode (
see page 59, as indicated by the speaker symbol
), the alarm is additionally signalled by an intermittent
acoustic signal. Information on what to do if this happens
can be found in chapter Malfunctions, warning and error
messages from page 44.
Setting the pressure monitoring
1. Press the activation key to the left of
ALARM
the display. The temperature
monitoring setting is automatically
activated.
2. Turn the turn control until the pressure
monitoring entry
3. Accept the selection by pressing the
confirmation key. The lower alarm limit
is automatically selected.
4. By turning the turn control, adjust the
desired lower alarm limit, in the exam-
ple on the right 30 mbar.
5. Accept the selection by pressing the
confirmation key. The upper alarm limit
is automatically highlighted.
D39374 | Date 08/2018
is shown (Fig. 30). If the
is highlighted.
Operation and control
min
160
auto
Sound
,
Fig. 30
Pressure monitoring triggered
ALARM
max
190
.0 °C .0 °C
+ -
5.0
K
VACUUM
586
In 1
mb
Set 500
mb
ALARM ALARM
min max
max
100 120
000°C
.0 °C .0 °C
min
auto
000°C
auto off
+ -
0.0
+
K
99K
-
ALARM
max
500
mb
min
120
mb
ALARM
max
500
mb
min
120
mb
ALARM
max
500
mb
min
30
mb
ALARM
max
500
mb
min
30
mb
41