Memmert VO Series Operating Manual page 36

Operation and control
To deactivate the timer, open the timer display by pressing the
activation key again and then turning the turn control to
reduce the timer setting until --:-- is displayed. Press the
confirmation key to confirm.
5.3.6 Program mode
In this operating mode, programs saved in the appliance can be started with different
combinations of individual parameters (temperature, Pressure) at staggered intervals,
which the appliance then automatically processes in sequence. These programs are
not created directly at the appliance but externally at a computer / laptop and using
AtmoCONTROL software. Transfer to the appliance is possible using the provided USB
storage medium or via Ethernet.
A description of how to create and save programs can be found in the sepa-
rate AtmoCONTROL software manual.
Starting a program
1. Press the activation key on the right of
the status display. The current operat-
ing mode is highlighted automatically,
in this example
2. Turn the turn control until the
symbol is highlighted. The current
program is displayed, in this example
Test 012
.
Only the program currently selected in menu mode and shown in the display can be
used. If you want to process another program, you need to activate it in menu
mode first (see description starting on page 59).
3. To start the program, press the confir-
mation key. The program is activated.
The display shows:
►
the program description (in this exam-
Test 012
ple )
►
the program segment description, in
Ramp 1
this example
►
the current run (in case of loops)
You cannot change any parameters (e.g. the temperature) at the appliance while a
program is running. However, the displays
36
Manual mode
(

start
13.Sept.2012 Fr 20.10.2010 20:31
0
manueller Betrieb Manual mode
% %
Activate
).
GRAPH GRAPH APH
80 80
0°C
40 40
off
ALARM
and
TIMER
--
h
End
9:00 23.11.
17:44
12.Sept.2012
Test 012
ready
12.Sept.2012
Test 012
Ramp 1
GRAPH
can still be used.
D39374 | Date 08/2018
--
m
10:44
10:44