Memmert VO Series Operating Manual page 24

Delivery, transport and setting up
3.5.4 Adjusting doors
Due to the conditions at the installation site, it may be necessary to adjust the doors.
Adjusting the door in height
1. Open set screw on the front side of the door hinge with Allen key size 2 (Fig. 17).
2. Turn the door bearing (eccentric) clockwise or counter-clockwise with a slotted screw-
driver as required (Fig. 18).
Top hinge
Clockwise
Counter-clockwise
Fig. 17 Set screw
3. If the doors are adjusted, clamp the set screw again.
Set distance from door to appliance
NOTICE
►
The distance between door and seal should be chosen so that the door presses
against the seal. If the distance
between door and seal is too great,
the appliance may leak.
1. Loosen the Phillips screw of the lock-
ing bolt holder on the lower cross
frame with a screwdriver (Fig. 19).
2. Move the locking piece inwards or
outwards.
3. Fasten the locking piece with the Phil-
lips screwdriver.
24
down Clockwise
up Counter-clockwise
Bottom hinge
Fig. 18 Turn the collar of the bearing on
the slot
Fig. 19 Locking bolt holder
up
down
D39374 | Date 08/2018