Table of Contents
Advertisement
Avionic Installations Service/Parts Manual
AUDIO CONTROL PANEL & SELECTOR SWITCH INSTALLATIONS
Detail B
MODIFICATION NOTES:
1.
Potentiometer to be adjusted to middle adjustment range.
2.Add jumper wire to solder pads between pins 7 and 18 only when the 200A or 300A
autopilot is installed.
3. Punch out intended hole on CLARE RELAYS after relay is installed and circuit board
assembly is cleaned.
4.
CAUTION
When replacing or adding diodes, note diode direction on printed circuit
board.
Damage to components or electrical system may result if improperly installed.
If
an autopilot is to be installed, items 61 & 62 must be ordered separately and installed
as shown.
If a second ADF is to be installed, item 63 must be ordered separately and installed as
shown.
INSTALLATION B - AUDIO CONTROL PANEL WITH INCANDESCENT LIGHTING AND 400
MARKER BEACON - 1982 & ON MODELS WITH THREE TRANSMITTERS OR DUAL ADF's
Figure 4-3. Audio Control Panel & Selector Switch Installations - All 1982 & On Models
With Three Transmitters or Dual ADF's Only (Sheet 3 of 3)
4-80
Hide quick links:
Advertisement
Table of Contents
