2. Fitting
2.1.2
Fitting onto a wall
Fig. 2/4: Dimensions in [mm]
2−8
For fitting onto a wall the support must be mounted firmly on
a flat fastening surface. To do this use two countersunk
screws of size M3x6 or longer. Dimensions for the fastening
holes as well as for the necessary fitting space are shown in
the following diagram.
85
Please note
Make sure that there is sufficient space for connecting the
cable and for inserting the handheld. Tighten the screws
with max. 0.6 Nm.
Festo P.BE−CPX−MM I−1−EN en 0305NH