Checking The Oil Level; Oil Change - WAGNER Cobra 40-10/2K Operating Manual

VERSION 04/2018
OPERATING MANUAL

8.2.7 CHECKING THE OIL LEVEL

1. Start up the pump for a short time without any product.
2. Then read oil level A.
Dismount the pump and place it upside down on a suitable
underlay and position it horizontally.
Observe the fill level marking X on the oil tank.
Oil level A in the oil tank (3) has to be within the specified
markings (X).
If the level deviates from these markings, the hydraulic oil must
be topped up or removed by extraction.
Procedure
1. Unscrew and remove threaded plug (5).
2. Top up oil to level A (middle of marking X).
3. Start up the pump for a short time without any product and
check for air bubbles.
4. Screw in threaded plug (5) and tighten with 2 Nm; 1.5 lbft.
NOTICE
Using hydraulic oil
Using the wrong hydraulic oil can cause a malfunction.
Use only original hydraulic oil - Wagner order no. 322912 (250 ml or 15 cu inch).

8.2.8 OIL CHANGE

Perform oil change after 500 service hours or once a year.
Necessary accessories:
Order no. 322911 - Oil filling set
NOTICE
Using hydraulic oil
Using the wrong hydraulic oil can cause a malfunction.
Use only original hydraulic oil - Wagner order no. 322912 (250 ml or 15 cu inch).
ORDER NUMBER DOC 2349980
Cobra 40-10 / 2K
3
5
max.
min.
B_05069
A
42