HP HPE G2 Series User Manual page 77

Network Settings page
The Network Settings page allows you to edit the IP Configuration, Web/REST API access configuration,
SSH/FTP Configuration, Network Time Protocol, Date/Time Settings, and daylight-savings time.
To access the Network Settings page, select Settings > Network Settings.
You can also perform the following tasks on this page:
• Set Certificate Key—Set the SSL certificate key length (1024/2048 bits).
• Change Link Speed— Set the Ethernet link speed (Auto Negotiation, 10/100 Mbps, or 1GMbps).
• Syslog Configuration—Configure the system log. Add the Syslog server address, server port, and then
enable the access to the Syslog.
IP configuration
On the Network Settings page, select the desired options in the IP Configuration section.
Procedure
1. If using IPv4, select one of the following Boot Mode options:
• To manually enter an IP address, select Static, and then enter the following information:
◦ IPv4 address
◦ Network Mask
◦ Gateway
• To autoconfigure the PDU IP address, select DHCP.
Configuring RESTapi access
Remote configuration 77