Connecting The Pdu; Connecting The Pdu To A Power Source; Network Management Module - HP HPE G2 Series User Manual

Connecting the PDU

Connecting the PDU to a power source

Always follow local and national codes when installing the PDU. The PDU must be connected to a dedicated
circuit protected by a branch circuit breaker matching the PDU input plug type.
NOTE: Make sure that the PDU power cord is long enough to reach the PDU power source.
Procedure
1. Turn the feed circuit breaker Off.
2. Make sure that all circuit breakers on the PDU are set to On.
3. Connect the PDU to an appropriately rated branch circuit.
NOTE: See the label on the PDU for the input ratings.
4. Turn the feed circuit breaker On.
The OLED screen displays a status bar when the PDU operating system is loading. When complete, the
Main Menu displays on the OLED screen. On Switched PDUs and Switched and Metered PDUs, a light
indicates each outlet as it is powered up.

Network management module

The Hewlett Packard Enterprise G2 Series Metered, Switched, and Metered & Switched Power Distribution
Units have an integral and hot swappable Network Management Module. The Network Management Module
contains the OLED interface, control buttons, USB, Ethernet, Serial and Sensor ports, and a recessed Reset
Button.
50 Connecting the PDU