Updating The Pdu Firmware Using Bootloader Mode; Firmware Recovery With Bootloader Mode - HP HPE G2 Series User Manual

7. Log in with administration privileges.
8. Enter sys upd lan.
The following message displays.
System will enter upgrade mode after reboot
System Reboot now
Are you sure?(Y/N)
9. Enter Y.
When the upload is complete, the system reboots automatically.
10. It is not always required to update Web or Bootloader files when the firmware is updated. However, a
user can upload these file types in SSH.
a. Log in to an FTP program.
b. Overwrite the outdated files with the updated web files, found on the customer login at www.hpe.com
or from your regional sales manager.

Updating the PDU Firmware using Bootloader mode

Procedure
1. Navigate to www.hpe.com and download the most recent firmware version, HPE.bin.
2. Save this file to a USB drive.
3. Insert the USB drive into the USB port of the Network Management Module.
4. Press Select to enter USB mode on the PDU.
5. Navigate to Setup > USB and click Yes to confirm entering USB mode.
6. To upload the new firmware, select F/W Up and click Yes.
7. The OLED displays the firmware update progress.
8. When the update is complete, remove the USB drive.
9. To exit USB mode, select Quit from the USB menu.
10. To confirm exit, click Yes.
11. The PDU reboots automatically.
12. To confirm the firmware uploaded successfully, navigate to Setup > Device > Firmware.

Firmware recovery with bootloader mode

Firmware, configuration files, and bootloader files are updated following the instructions listed, but each
update type must be done separately. Web files can be updated in conjunction with any of the other updates.
For example, you can update firmware and web files in a single step, but firmware and configuration files
must be done separately.
Appendix 149