Installing The Mounting Hardware; Vertical (0U) Pdu-Single Installation - HP HPE G2 Series User Manual

Installing the mounting hardware

To assist with mounting in non-HPE racks, each vertical PDU has two mounting hole locations (M1 and M2)
on the sides and back of the PDU for installing the buttons. When installing the mounting buttons, use either
the M1 or M2 mounting holes as a set.
Installing the mounting button–outlets facing the center of the rack
Procedure
1. Align and install the mounting buttons in the screw holes on the face opposite of the receptacles.
2. Install the PDU by inserting the mounting buttons in the keyhole slots on the PDU mounting bracket in the
rack.
Installing the mounting button–outlets facing the back or front of the rack
Procedure
1. Align and install the mounting buttons in the screw holes on the side of the PDU.
2. Install the PDU by inserting the mounting buttons in the keyhole slots on the PDU mounting bracket in the
rack.
Vertical (0U) PDU—single installation
A single Vertical PDU can be installed with the outlets facing one of the following ways:
• Outlets facing the center of the rack
24 Installing the PDU