Upgrading configuration with bootloader mode
Procedure
1. Make the PDU accessible through the USB port.
a. Navigate to device Configuration > USB Settings.
b. Select Enable USB Access.
2. Upload the configuration.
a. Copy conf.ini to a USB drive.
b. Insert the USB drive to the PDU.
c. Enter the USB mode in the OLED display.
d. Select Conf up.
e. After the operation is complete, remove the USB drive.
f. Exit the USB mode.
Appendix C: PDU alarms
Type
PDU unit
Input phase
150
Appendix
Alarms
•
PDU unit Active Power Above upper critical
•
PDU unit Active Power Above upper warning
•
PDU unit Active Power Below lower warning
•
PDU unit Active Power Below lower critical
•
Input Phase X Voltage Above upper critical
•
Input Phase X Voltage Above upper warning
•
Input Phase X Voltage Below lower warning
•
Input Phase X Voltage Below lower critical
•
Input Phase X Current Above upper critical
•
Input Phase X Current Above upper warning
•
Input Phase X Current Below lower warning
•
Input Phase X Current Below lower critical
Table Continued