HP HPE G2 Series User Manual page 54

• Parity: None
• Stop bits: 1
• Flow control: None
5. Use the default initial login credentials.
The user name and password are case sensitive.
• User name: admin
• Password: 12345678 (or your new password)
The HPE> prompt appears after you have log in.
6. To configure the network settings, at the CLI prompt, enter the appropriate net command and press Enter.
All commands are case sensitive. Enter ? to for a list of available commands.
a. To enable the IPv4 DHCP by default:
• Enter the following command:
net tcpip dhcp
• Enter Y to confirm and the Network Management Module will reboot.
b. To set a static IPv4 configuration:
• Enter the following command:
net tcpip static ip-address netmask gateway
For example, net tcpip static 192.168.1.100 255.255.255.0 192.168.1.1
• Enter Y to confirm and the Network Management Module will reboot.
54 Connecting the PDU