Block Diagrams - Siemens SIMODRIVE 611 Planning Manual

1 Overview of the Drive System
1.2 Engineering steps
Phase 1 when
1
engineering
Phase 2 when
engineering
Selecting cable
and conductor
protective devices
and switching
devices
1-22
Selecting the components
Motor selection
Position sensing
Power modules
Control modules
Infeed modules
Line supply connection
Fig. 1-4 Selecting the components
Connection configuration
Important
circuit information
Electrical cabinet, EMC

Block diagrams

Connecting diagrams
Dimension sheets
Fig. 1-5 Connection configuration
The cable and conductor protective devices and switching devices should
be selected taking into account the relevant Standards, regulations and the
requirements at the point of installation.
Reference: /NCZ/
Reference: /NSK/
refer to Section 3
refer to Section 3
refer to Section 4
refer to Section 5
refer to Section 6
refer to Section 7
refer to Section 9
refer to Section 10
refer to Section 11
refer to Section 12
refer to Section 13
Catalog Connection Technology
and System Components
Catalog Low–Voltage
Switchgear
 Siemens AG 2001 All rights reserved
SIMODRIVE 611 Planning Guide (PJU) – 05.01 Edition
05.01
J