Rear Panel Features; If Outputs - Sma (Female); Lo In; Test Set I/O - Keysight Technologies PNA Series Installation Manual

System Description
N5292A Test Controller Description

Rear Panel Features

Figure 2-8 N5292A Option 200 (2-Port) and 400 (4-Port) – Rear Panel Features
IF OUTPUTS – SMA (female)
— D (from the test set to the analyzer's IF D Input)
— C (from the test set to the analyzer's IF C Input)
— R (from the test set to the analyzer's IF R Input)
— A (from the test set to the analyzer's IF A Input)
— B (from the test set to the analyzer's IF B Input)

LO IN

This input is from the LO drive of the analyzer. The signal is split and amplified
and then output to the front panel of the N5292A Option 200/400.

Test Set I/O

The test set interface connector is used digitally control to the test set from the
analyzer.

Line Module

This assembly houses the line cord connection. Line voltage selection is
automatic and no setting is required.

Power Cords

A line power cord is supplied in one of several configurations, depending on
the destination of the original shipment. Keysight can supply additional
certified power cords to meet region electrical supply and receptacle
configurations. Please refer to our website at:
assistance in power cord selection.
Verify that the premise electrical voltage supply is within the range
specified on the instrument.
2- 18
www.keysight.com
Keysight N5290/1A Installation Guide
for