Keysight Technologies PNA Series Installation Manual page 72

System Installation
Running the Installation Calibration
3. Press Installation Cal. In the dialog box opens, connect a load and press
Measure. Refer to
For best results use a load that extends to 125 GHz.
Figure 3-20 Millimeter Installation Cal – Dialog Box
4. When finished, the following dialog box is displayed. Remove the load and
press Finish. Refer to
Figure 3-21 Millimeter Installation Cal – Dialog Box Load Calibration "Finish"
5. The following dialog box is displayed until the calibration is finished (i.e.,
Is is not necessary to connect a calibration kit open for this step). Refer to
Figure
Figure 3-22 Millimeter Installation Cal – Dialog Box Open-circuit Calibration Ongoing /
"Finish"
3- 24
Figure 3-20.
Figure 3-21.
3-22.
Keysight N5290/1A Installation Guide